For the Magnetic level meter with a fixed length from the center of the flange out of the storage tank

For the Magnetic level meter with a fixed length from the center of the flange out of the storage tank

The Magnetic level meter is used for liquid measurement in open or pressure vessels. It can be sealed, leak proof and measure the liquid level safely and reliably in the whole process under the conditions of temperature, pressure, viscosity and strong corrosion. No blind area, eye-catching display, intuitive reading and large measurement range. In industrial production, the use of Magnetic level meter is relatively common. Because the conditions of tank farms are very different and the sizes and volumes of various storage tanks are not unified, the basic instrument products are customized according to the requirements of customers. However, sometimes when users install, they will respond that the size of magnetic flap is too long to be installed normally or correctly, The measuring state of the magnetic flap is abnormal, which shortens the service life of the instrument. In order to solve the problem of confusing users for a long time。

For the liquid level gauge with a fixed length from the center of the flange of the storage tank, the precautions are to add a flange in the middle or fixed support near the ear during installation, so as to increase the strength and overcome its own weight, so as to keep the instrument in a stable state.

Installation points of Magnetic level meter:

1. When installing and selecting the position of the Magnetic level meter, pay attention to avoid selecting the outlet or inlet away from the material, so as to prevent the material fluid from affecting the measurement result of the liquid level gauge due to the drastic change of its own local area;

2. When equipped with remote transmission supporting instruments, pay attention to the following:

1) the sensing surface of remote transmission supporting instrument shall face and close to the main pipe;

2) the wiring between the remote transmission supporting instrument and the display instrument or industrial computer is laid through a single protective tube or with a shielded two core cable;

3) make the remote supporting instrument close to the main pipe of the liquid level gauge and fix it with stainless steel hoop (iron hoop is prohibited);

4) after the wire inlet hole of the junction box is laid, it is required to be well sealed to prevent the remote transmission supporting instruments from working normally due to the intrusion of rain and moisture. After the inspection and commissioning of the junction box is completed, it shall be covered in time.

5) the point of remote transmission supporting instrument shall be at the same level as the point indication of liquid level gauge